Agent Auto Unit Replacement - Avaya 4524GT Configuration Manual

System configuration using ACLI

Agent Auto Unit Replacement

Use ACLI commands in the following sections to manage and configure AAUR. You can
currently manage this functionality only through ACLI.
stack auto-unit-replacement-image enable command
Use the stack auto-unit-replacement-image enable command to enable AAUR.
Because AAUR is enabled by default, use this command only if this functionality was previously
disabled.
The syntax for this command is
stack auto-unit-replacement-image enable
Run the stack auto-unit-replacement-image enable command in Global
Configuration command mode.
no stack auto-unit-replacement-image-enable command
Use the no stack auto-unit-replacement-image enable command to disable
AAUR. Because AAUR is enabled by default, you must run this command if you do not want
AAUR functionality on a switch.
The syntax for this command is
no stack auto-unit-replacement-image enable
The no stack auto-unit-replacement-image enable command is executed in the
Global Configuration command mode.
default stack auto-unit-replacement-image enable command
Use the default stack auto-unit-replacement-image enable command to set the
AAUR functionality to the factory default of enabled.
The syntax of this command is
default stack auto-unit-replacement-image enable
Run the default stack auto-unit-replacement-image enable command in Global
Configuration command mode.
108 Configuration — System April 2011