Avaya 4524GT Configuration Manual page 149

no rate-limit command
The no rate-limit command disables rate-limiting on the port.
The syntax for the no rate-limit command is:
no rate-limit [port <portlist>]
Run the no rate-limit command in Interface Configuration command mode.
The following table describes the parameters for this command.
Table 65: No rate-limit parameters
Parameters
port <portlist>
default rate-limit command
The default rate-limit command restores the rate-limiting value for the specified port
to the default setting.
The syntax for the default rate-limit command is
default rate-limit [port <portlist>]
Run the default rate-limit command in Interface Configuration command mode.
The following table describes the parameters for this command.
Table 66: Default rate-limit parameters
Parameters
port <portlist>
Configuration — System
Specify the port numbers to disable for rate-limiting. Enter the
port numbers to disable.
Important:
If you omit this parameter, the system uses the port number
you specified in the interface
Specify the port numbers to reset rate-limiting to factory default.
Enter the port numbers to set rate-limiting to default.
Important:
If you omit this parameter, the system uses the port number
interface
you specified in the
General switch administration using ACLI
Description
command.
Description
command.
April 2011 149