Procedure steps
1. From the navigation tree, double-click Edit.
2. In the Edit tree, double-click Diagnostics.
3. In the Diagnostic tree, double-click 802.1AB.
4. In the 802.1AB tree, double-click Port dot3.
5. On the work area, click the Local Link Aggregate tab.
Variable definitions
The following table describes the Local Link Aggregate tab fields.
PortNum
LinkAggStatus
LinkAggPortId
Viewing LLDP local maximum frame information using EDM
Use the following procedure to display LLDP maximum frame size properties for the local
system.
Procedure steps
1. From the navigation tree, double-click Edit.
2. In the Edit tree, double-click Diagnostics.
3. In the Diagnostic tree, double-click 802.1AB.
4. In the 802.1AB tree, double-click Port dot3.
5. On the work area, click the Local Max Frame tab.
Configuration — System
Variable
LLDP Port dot3 configuration using EDM
Indicates the port number.
Specifies the link aggregation capabilities and the
current aggregation status of the link.
Contains the IEEE 802.3 aggregated port identifier,
aAggPortID (IEEE 802.3-2002, 30.7.2.1.1), derived
from the ifNumber of the ifIndex for the port component
in link aggregation. If the port is not in a link
aggregation state or does not support link
aggregation, this value is set to zero.
Value
April 2011
311