Restoring Configuration From A Binary File - Avaya 4524GT Configuration Manual

The script run command is executed in the Privileged EXEC command mode.
Table 26: script run command parameters
command.
Table 26: script run command parameters
<1-127>
<A.B.C.D>
<filename>
<1-8>

Restoring configuration from a binary file

You can restore the configuration from a binary file using the following commands:
• copy tftp config command
• copy usb config command
copy tftp config command
Use the copy tftp config to restore a configuration from a binary file from a TFTP server.
You can also use this command to copy the configuration of a switch in a stack to a stand-
alone switch and to replace units in the stack.
Important:
When you use the TFTP address parameter to perform copy or download commands, the
system overwrites the TFTP server address.
The syntax for the copy tftp config file is:
copy tftp config address <XXX.XXX.XXX.XXX> filename <name> unit <unit
number>
The copy tftp config command is executed in Privileged EXEC command mode.
Table 27: copy tftp config parameters
command.
Configuration — System
Parameters
on page 91
on page 92
on page 91 outlines the parameters for this
Description
The index of the ASCII configuration script
table entry to be used.
The IP address of the tftp server to load the
script.
The name of the file to be restored.
The unit number in which the USB device is
inserted in, if the unit is a part of the stack.
on page 92 outlines the parameters for this
Configuration files in ACLI
April 2011 91