Lldp Tx-Tlv Med Command - Avaya 4524GT Configuration Manual

Table 79: lldp tx-tlv dot3 command variables
port <portlist>
link-aggregation
mac-phy-config-status
maximum-frame-size
mdi-power-support

lldp tx-tlv med command

The lldp tx-tlv med command sets the optional organizationally specific TLVs for use by
MED devices to be included in the transmitted LLDPDUs. The syntax for the lldp tx-tlv
med command is:
lldp tx-tlv [port <portlist>] med [med-capabilities] [extendedPSE]
[inventory] [location] [network-policy]
The lldp tx-tlv med command is in the config-if command mode.
The following table lists the variables for the lldp tx-tlv med command.
Table 80: lldp tx-tlv med command variables
port <portlist>
med-capabilities
extendedPSE
inventory
location
network-policy
Configuration — System
Variables
Variables
Description
The ports affected by the command.
The link aggregation TLV.
The MAC/Phy configuration or status TLV.
Maximum Frame Size TLV.
The power via MDI TLV. This TLV is enabled by
default.
specifies the ports affected by the command
MED Capabilities TLV (MED TLVs are
transmitted only if MED Capabilities TLVs
are transmitted). This TLV is enabled by
default.
Extended PSE TLV This TLV is enabled by
default.
Inventory TLVs This TLV is enabled by
default.
Location Identification TLV This TLV is
enabled by default.
Network Policy TLV This TLV is enabled by
default.
Configuring LLDP using ACLI
Description
April 2011 169