Configuring Rate Limiting Using Edm - Avaya 4524GT Configuration Manual

Variable
PowerPriority
PowerLimit(watts)
Voltage(volts)
Current(amps)
Power(watts)

Configuring Rate Limiting using EDM

Use the following procedure to configure the Rate Limiting for a single port.
Procedure steps
1. From the navigation tree, double-click Edit.
2. In the Edit tree, double-click Chassis.
3. In the Chassis tree, double-click Ports.
4. On the work area, click the Rate Limit tab.
5. To a rate limit, click a TrafficType row.
6. Double-click the cell in the AllowedRate column.
7. Select a value from the list.
8. Double-click the cell in the Enable column.
9. Select a value from the list—true to enable the traffic type, or false to disable the
Variable definitions
Use the data in this table to configure rate limiting.
Configuration — System
as IP telephones, WLAN access points, and others can be classified
according to their power requirements.
Lets you set the power priority for the specified port to:
• critical
• high
• low
Specifies the maximum power that the switch can supply to a port.
The default value is 16W.
Indicates the voltage measured in Volts.
Indicates the current measured in amps.
Indicates the power measured in watts.
traffic type.
Configuring Rate Limiting using EDM
Value
April 2011 239