System configuration using ACLI
Table 87: default lldp tx-tlv med command variables
port <portlist>
med-capabilities
extendedPSE
inventory
location
network-policy
no lldp port command
The no lldp port command disables LLDP features on the port. The syntax for the no
lldp port command is
no lldp [port <portlist>] [config notification] [status]
Run the no lldp port command in Interface Configuration command mode.
no lldp med-network-policies command
The no lldp med-network-policies command disables LLDP MED policies for switch
ports. The syntax for the no lldp med-network-policies command is
no lldp med-network-policies [port <portList>] {voice|voice-
signaling}
Run the no lldp med-network-policies command in Interface Configuration command
mode.
The following table describes the variables for the no lldp med-network-policies
command.
174
Configuration — System
Variables
Description
specifies the ports affected by the command
MED Capabilities TLV (MED TLVs are
transmitted only if MED Capabilities TLVs
are transmitted). This TLV is enabled by
default.
Extended PSE TLV This TLV is enabled by
default.
Inventory TLVs This TLV is enabled by
default.
Location Identification TLV This TLV is
enabled by default.
Network Policy TLV This TLV is enabled by
default.
April 2011