Configuring Remote Access Using Edm - Avaya 4524GT Configuration Manual

System configuration using Enterprise Device Manager

Configuring remote access using EDM

Use this procedure to configure remote access for a switch.
Procedure steps
1. From the navigation tree, double-click Administration.
2. In the Administration tree, double-click Remote Access .
3. In the work area, click the Setting tab.
4. In the Telnet Remote Access Setting section, select a value from the Access list.
5. In the Telnet Remote Access Setting section, select a value from the Use List list.
6. In the SNMP Remote Access Setting section, select a value from the Access list.
7. In the SNMP Remote Access Setting section, select a value from the Use List
8. In the Web Page Remote Access Setting section, select a value from the Use List
9. In the SSH Remote Access Setting section, select a value from the Access list.
10. In the SSH Remote Access Setting section, select a value from the Use List list.
11. Click Apply .
Variable definitions
Use the data in this table to configure remote access for a switch.
Telnet Remote Access Setting
SNMP Remote Access Setting
212 Configuration — System
list.
list.
Variable Value
Specifies the remote access settings for
telnet sessions.
• Access—allows or disallows telnet access
to the switch
• Use List—enables (Yes) or disables (No)
the use of listed remote Telnet
information.
Specifies SNMP remote access settings.
April 2011