Avaya 4524GT Configuration Manual page 90

System configuration using ACLI
show script status command
Use the show script status command to view the status of one or all the entries. The
syntax for the show script status command is:
show script status [<1-127>]
The show script status command is executed in the Privileged EXEC command
mode.
Note:
By default, a script table index is present as a bootp entry. If a bootp server is connected to
the stack or switch, you can automatically configure the switch using an ASCII file present
on the bootp server.
The following is an example output for show script command:
4526T-PWR(config)#show script 2
Table index: 2
Load script on boot: Yes
Boot priority: 1
Script source: bootp://
Table 25: show script status parameters
<1-127>
script run command
Use the script run command to load the script from an ASCII file to a tftp server or USB
Mass Storage Device.
Important:
When you use the TFTP address parameter to perform copy or download commands, the
system overwrites the TFTP server address
The syntax for the script run command is:
script run { <1-127> | tftp <A.B.C.D> <filename> | usb [unit <1-8>
<filename>] }
90 Configuration — System
Parameters Description
The index of the entry to be used.
April 2011