Detailed Configuration Commands - Avaya 4524GT Configuration Manual

System configuration using ACLI
10. Enable the Protocol Identity TLV for transmission. (indicates the supported
11. Enable the MAC/PHY Configuration/Status TLV for transmission. (indicates the
12. Enable the Power Via MDI TLV for transmission. (indicates the MDI power support
13. Enable the Link Aggregation TLV for transmission. (indicates the link aggregation
14. Enable the Maximum Frame Size TLV for transmission. (indicates the maximum
15. Enable the Location Identification TLV for transmission. (indicates the physical
16. Enable the Extended Power-via-MDI TLV for transmission. (provides detailed
17. Enable the Inventory – Hardware Revision TLV for transmission. (indicates the
18. Enable the Inventory – Firmware Revision TLV for transmission. (indicates the
19. Enable the Inventory – Software Revision TLV for transmission. (indicates the
20. Enable the Inventory – Serial Number TLV for transmission. (indicates the serial
21. Enable the Inventory – Manufacturer Name TLV for transmission. (indicates the
22. Enable the Inventory – Model Name TLV for transmission. (indicates the model
23. Configure the location information for the LLDP-MED Location Identification TLV.
24. Enable the LLDP-MED Capabilities TLV for transmission (indicates the supported

Detailed configuration commands

The following section describes the detailed ACLI commands required to carry out the
configuration depicted by
194 Configuration — System
protocols by the LLDP sending port)
IEEE 802.3 duplex and bitrate capabilities and settings of the LLDP sending port)
capabilities of the LLDP sending port)
capability and status of the LLDP sending port)
frame size that can be handled by the LLDP sending port)
location of the LLDP sending port; three coordinate sets are available to configure
and send)
informations regarding the PoE parameters of the LLDP sending device)
hardware revision of the LLDP sending device)
firmware revision of the LLDP sending device)
software revision of the LLDP sending device)
number of the LLDP sending device)
manufacturer name of the LLDP sending device)
name of the LLDP sending device)
(There are three coordinate sets available for location advertisement.)
LLDP-MED TLVs and the LLDP-MED device type of the LLDP sending device)
Figure 13: LLDP configuration example on page 193
April 2011