Default Lldp Med-Network-Policies Command; Default Lldp Tx-Tlv Command - Avaya 4524GT Configuration Manual

config notification
status

default lldp med-network-policies command

The default lldp med-network-policies command configures LLDP MED policies
for switch ports to default values. The syntax for the default lldp med-network-
policies command is:
default lldp med-network-policies [port <portList>] {voice|voice-
signaling}
Run the default lldp med-network-policies command in Interface Configuration
command mode.
The following table describes the variables for the default lldp med-network-
policies command.
Table 83: default lldp med-network-policies command variables
port <portlist>
voice
voice-signaling

default lldp tx-tlv command

The default lldp tx-tlv command sets the LLDP Management TLVs to their default
values. The syntax for the default lldp tx-tlv command is
default lldp tx-tlv [port <portlist>][port-desc] [sys-name] [sys-
desc] [sys-cap] [local-mgmt-addr]
Run the default lldp tx-tlv command in Interface Configuration command mode.
The following table describes the variables for the default lldp tx-tlv command.
Configuration — System
Variables
Variable
Description
Set the config notification to its default value
(disabled).
Set the LLDPU transmit and receive status to the
default value (txAndRx).
Specifies the port or ports on which to configure
default LLDP MED policies.
Specifies the default voice network policy. The default
value is 46.
Specifies the default voice signalling network policy.
Configuring LLDP using ACLI
Value
April 2011 171