System configuration using ACLI
Variable definitions
The following table defines optional parameters that you can enter after the show tdr test
command.
<WORD>
Enabling Autotopology
Use ACLI to configure the Enterprise Autotopology protocol.
For more information about Autotopology, see http://www.avaya.com. (The product family for
Enterprise and Autotopology is Data and Internet.)
To enable autotopology using ACLI, see the following sections:
•
autotopology command
•
no autotopology command
•
default autotopology command
•
show autotopology settings command
•
show autotopology nmm-table command
autotopology command
The autotopology command enables the Autotopology protocol.
The syntax for the autotopology command is
autotopology
Run the autotopology command in Global Configuration command mode.
no autotopology command
The no autotopology command disables the Autotopology protocol.
The syntax for the no autotopology command is
no autotopology
Run the no autotopology command in Global Configuration command mode.
144
Configuration — System
Variable
on page 144
on page 144
on page 145
Value
Specifies a port or list of ports.
on page 145
on page 145
April 2011