System configuration using ACLI
I 00:02:39:52 23 #0 Session closed (console cable disconnected),
serial connection, access mode: no security
Important:
When loading an ASCII configuration file on switch, removing the console cable does not
involve a logout event.
Configuring LLDP using ACLI
You can enable and configure LLDP using ACLI. For more information about LLDP, see
Layer Discovery Protocol (IEEE 802.1AB) Overview
following commands:
•
lldp command
•
lldp port command
•
lldp tx-tlv command
•
lldp tx-tlv dot1 command
•
lldp tx-tlv dot3 command
•
show lldp command
•
default lldp command
•
default lldp port command
•
default lldp tx-tlv command
•
default lldp tx-tlv dot1 command
•
default lldp tx-tlv dot3 command
•
no lldp port command
•
no lldp tx-tlv command
•
no lldp tx-tlv dot1 command
•
no lldp tx-tlv dot3 command
•
show lldp port command
•
LLDP configuration example
lldp command
The lldp command sets the LLDP transmission parameters. The syntax for the lldp
command is
164
Configuration — System
on page 164
on page 165
on page 167
on page 168
on page 168
on page 176
on page 170
on page 170
on page 171
on page 172
on page 173
on page 174
on page 175
on page 175
on page 176
on page 178
on page 192
on page 63. This section covers the
Link
April 2011