Configuring An Ipv6 Address Using Edm - Avaya 4524GT Configuration Manual

System configuration using Enterprise Device Manager
ReasmOKs
ReasmFails
InMcastPkts
OutMcastPkts
Important:
You can also change the Poll Interval by selecting and clicking on a value from the drop
down list. The default value for the Poll Interval is 10ms.

Configuring an IPv6 address using EDM

Use this procedure to configure an IPv6 address for a switch or stack.
Procedure steps
1. From the navigation tree, double-click IPv6 .
2. In the IPv6 tree, double-click IPv6.
3. In the work area, click the Addresses tab.
4. Click Insert.
5. Accept the default IfIndex value.
6. In the Addr box, type an IPv6 address.
7. In the AddrLen box, type the IPv6 prefix length.
8. In the Type section, click a radio button.
256 Configuration — System
Variable
OR
Click Vlan to select a value from the list.
Value
Indicates the number of IP datagrams
successfully reassembled.
Indicates the number of failures detected by
the IP re-assembly algorithm (for whatever
reason: timed out, errors). Note that this is
not necessarily a count of discarded IP
fragments since some algorithms (notably
the algorithm in RFC 815) can lose track of
the number of fragments by combining them
as they are received.
Indicates the number of IP multicast
datagrams received.
Indicates the number of IP multicast
datagrams transmitted.
April 2011