Configuring Ipv6 Static Routes Using Edm - Avaya 4524GT Configuration Manual

System configuration using Enterprise Device Manager

Configuring IPv6 static routes using EDM

Use the following procedure to configure IPv6 static routes for a switch or stack.
Procedure steps
1. From the navigation tree, double-click IPv6.
2. In the IPv6 tree, double-click IPv6.
3. On the work area, click the Static Routes tab.
4. On the toolbar, click Insert.
5. Configure the parameter as required.
6. Click Insert to save the changes.
Variable definitions
The following table defines the variables for the Static Routes window.
Dest
PrefixLength
NextHop
258 Configuration — System
The Insert Static Routes dialog box appears.
Variable Value
Specifies the destination IP address of this
route. An entry with a value of 0.0.0.0 is
considered a default route. Multiple routes to
a single destination can appear in the table,
but access to such multiple entries depends
on the table-access mechanisms defined by
the network management protocol in use.
Indicates the number of leading one bits
which form the mask to be logical-ANDed
with the destination address before being
compared to the value in the
rcIpv6StaticRouteDestAddr field.
Specifies the IP address of the next hop of
this route. (In the case of a route bound to an
interface which is realized through a
broadcast media, the value of this field is the
agent's IP address on that interface).
April 2011