Assigning And Clearing Ip Addresses For Specific Units - Avaya 4524GT Configuration Manual

Run the no ip default-gateway command in Global Configuration command mode.
Important:
When you change the IP gateway, connectivity to Telnet and the Web Interface can be
lost.
show ip command
The show ip command displays the IP configurations, BootP mode, stack address, switch
address, subnet mask, and gateway address. This command displays these parameters for
what is configured, what is in use, and the last BootP. The sub command, Display DNS
configuration, provides information about the DNS configuration.
The syntax for the show ip command is
show ip [bootp] [default-gateway] [address]
Run the show ip command in User EXEC or Privileged EXEC command mode.
If you do not enter any parameters, this command displays all IP-related configuration
information.
The following table describes the variables for the show ip command.
Table 53: show ip parameters
Variables
bootp
default-gateway
address

Assigning and clearing IP addresses for specific units

You can use ACLI to assign and clear IP addresses for a specific unit in a stack. For details,
see the following sections:
• ip address unit command
• no ip address unit command
ip address unit command
The ip address unit command sets the IP address and subnet mask of a specific unit in
the stack.
Configuration — System
BootP-related IP information.
The IP address of the default gateway.
The current IP address.
on page 137
on page 138
General switch administration using ACLI
Description
April 2011 137