Domain Name Server (Dns) Configuration - Avaya 4524GT Configuration Manual

System configuration using ACLI
count <1–9999> | continuous
timeout | -t | <1–120>
interval <1–60>
debug
telnet command
Use the telnet command to establish communications with another switch during the current
ACLI session. Communication can be established to only one external switch at a time using
the telnet command.
The syntax for this command is
telnet <ipv6_address | dns_host_name>
Substitute <ipv6_address | dns_host_name> with either the IPv6 address or the DNS
host name of the unit with which to communicate.
Run this command in User EXEC command mode.

Domain Name Server (DNS) Configuration

Use domain name servers when the switch needs to resolve a domain name (such as
avaya.com) to an IP address. Use the following commands to configure the switch domain
name servers:
• show ip dns command
• ip domain-name command
• no ip domain-name command
• default ip domain-name command
• ip name-server command
• no ip name-server command
160 Configuration — System
Parameter
on page 161
on page 161
on page 162
Description
Set the number of ICMP packets to be sent. The
continuous mode sets the ping running until the user
interrupts it by entering Ctrl+C.
Set the timeout using either the timeout with the -t
parameter followed by the number of seconds the
switch must wait before timing out.
Specify the number of seconds between transmitted
packets.
Provide additional output information such as the
ICMP sequence number and the trip time.
on page 161
on page 161
on page 162
April 2011