Setting Tftp Parameters; Setting A Default Tftp Server; Displaying The Default Tftp Server - Avaya 4524GT Configuration Manual

System configuration using ACLI

Setting TFTP parameters

Many processes in the switch can use a Trivial File Transfer Protocol (TFTP) server. The
following sections describe how to set a default TFTP server for the switch and how to clear
these defaults through ACLI:
•

Setting a default TFTP server

•

Displaying the default TFTP server

• Clearing the default TFTP server
Important:
When you use the TFTP address parameter to perform copy or download commands, the
system overwrites the TFTP server address
Setting a default TFTP server
The switch processes that use a TFTP server often give the switch administrator the option to
specify the IP address of a TFTP server to use. Instead of entering this address every time,
the switch can store a default IP address.
Specify a default TFTP server for the switch with the tftp-server command. The syntax of
this command is
tftp-server [<ipv6_address> | <XXX.XXX.XXX.XXX>]
To complete the command, replace either ipv6_address with the IPv6 address or
<XXX.XXX.XXX.XXX> with the IPv6 or IP address of the default TFTP server. You must run
this command in Global Configuration command mode.
Displaying the default TFTP server
You can display the default TFTP server configured for the switch in ACLI at any time by using
the show tftp-server command. This command has no parameters and you run it in
Privileged EXEC mode.
76 Configuration — System
on page 76
on page 76
on page 77
April 2011