No Telnet-Access Command - Avaya 4524GT Configuration Manual

System configuration using ACLI
retry <1-100>
inactive-timeout <0-60>
logging {none | access | failures |
all}
[source-ip <1-50>
<XXX.XXX.XXX.XXX> [mask
<XXX.XXX.XXX.XXX>]

no telnet-access command

The no telnet-access command disables the Telnet connection. The no telnet-
access command is accessed through the console serial connection.
The syntax for the no telnet-access command is:
no telnet-access [source-ip [<1-50>]]
Run the no telnet-access command in Global Configuration command mode.
The following table describes the variables for the no telnet-access command.
Table 34: no telnet-access parameters
Variables
source-ip [<1-50>]
98 Configuration — System
Parameters
Disable the Telnet access.
When you do not use the optional parameter, the source-ip list
is cleared, which means the first index is 0.0.0.0./0.0.0.0. and
the second to fiftieth indexes are
255.255.255.255/255.255.255.255.
When you specify a source-ip address, the specified pair is
255.255.255.255/255.255.255.255.
Description
Specify the number of times the user can enter an
incorrect password before the connection closes.
Enter an integer from 1–100.
Specify in minutes the duration before an inactive
session terminates.
Specify the events for which you want to store details
in the event log:
none: Do not save access events in the log.
access: Save only successful access events in the
log.
failure: Save failed access events in the log.
all: Save all access events in the log.
Specify the source IP address from which connections
can occur. Enter the IP address in dotted-decimal
notation. Mask specifies the subnet mask from which
connections can occur; enter IP mask in dotted-
decimal notation.
Description
April 2011