Saving The Current Configuration - Avaya 4524GT Configuration Manual

System configuration using ACLI
Table 27: copy tftp config parameters
Parameter
address
<XXX.XXX.XXX.XXX>
filename <name>
unit <unit number>
copy usb config command
Use the copy usb config command to restore a configuration file from a USB Mass Storage
Device. The syntax for the copy usb config command is:
copy usb config filename <name>
The copy usb config command is executed in the Privileged EXEC command mode. The
only parameter for this command is the name of the file to be retrieved from the USB device.

Saving the current configuration

The configuration currently in use on a switch is regularly saved to the flash memory
automatically. However, you can manually initiate this process using the copy config
nvram command. This command takes no parameters and you must run it in Privileged EXEC
mode. If you have disabled the AutosaveToNvramEnabled function by removing the default
check in the AutosaveToNvRamEnabled field, the configuration is not automatically saved to
the flash memory.
write memory command
The write memory command copies the current configuration to NVRAM. The syntax for the
write memory command is:
write memory
The write memory command is in the exec command mode.
The write memory command has no parameters or variables.
save config command
The save config command copies the current configuration to NVRAM. The syntax for the
save config command is:
92 Configuration — System
Description
The IP address of the TFTP server.
The name of the file to be retrieved.
The number of the stack unit.
April 2011