System configuration using ACLI
Displaying the IPv6 address for a switch or stack
Use the following procedure to display the IPv6 address for a switch or stack:
show ipv6 address
Enter the following command:
show ipv6 address
show ipv6 address interface
Enter the following command to display all or a specific ipv6 interface address.
show ipv6 address interface <ipv6_address>
Job aid
The following graphic shows the results of theshow ipv6 address interface
command.
4526(config)#show ipv6 address interface
=======================================================================================
=======================================================================================
IPV6 ADDRESS
-------------------------------------------------------------------------------------------------------------------------------------------------
3000:0:0:0:0:0:0:99
fe80:0:0:0:211:f9ff:fe34:8800
2out of 2Total Num of Address Entries displayed.
Configuring IPv6 interface properties
Use the following procedure to configure the IPv6 interface, create the VLAN IPv6 interface,
and set the parameters
Enter the following command:
118
Configuration — System
Address Information
VID/BID/
TYPE
ORIGIN
TID
V-1
UNICAST
MANUAL
V-1
UNICAST
OTHER
STATUS
PREFERRED
UNKNOWN
April 2011