Viewing The Switch File Server Ip Address Tlv Configuration Using Acli - Avaya 4524GT Configuration Manual

the SIP configuration information, because the IP Phone retrieves information related to the
SIP domain, port number and transport protocol from the file server.
Important:
The switch does not support the advertisement of IPv6 addresses to Avaya IP phones.
Prerequisites
Log on to the Global Configuration mode in ACLI.
Procedure steps
1. Enable file server IPv4 address advertisement to Avaya IP phones by using the
2. Delete file server IPv4 addresses configured on the switch by using the following
Variable definitions
<1-4>
<A.B.C.D>
Viewing the switch file server IP address TLV configuration using
ACLI
Use this procedure to display information about the defined local file server IP address that
switch ports advertise to connected Avaya IP phones.
You can define IP addresses for a maximum of 4 local file servers.
Important:
The switch does not support the advertisement of IPv6 addresses to Avaya IP phones.
Configuration — System
following command:
lldp vendor-specific avaya file-server [<1-4>] <A.B.C.D>
[[<1-4>] <A.B.C.D>] [[<1-4>] <A.B.C.D>]
command:
default lldp vendor-specific avaya file-server <1-4>
Variable Value
Specifies the file server number.
Note:
When you advertise the IPv4 address of file
server 1 only, you do not have to enter a file
server number before you enter the IP
address.
Specifies the file server IPv4 address.
Configuring LLDP using ACLI
April 2011 185