Run the no ip bootp server command in Global Configuration command mode.
default ip bootp server command
The default ip bootp server command uses BootP when needed.
The syntax for the default ip bootp server command is:
default ip bootp server
Run the default ip bootp server command in Global Configuration command mode.
Customizing ACLI banner
You can configure the banner that is presented when a user logs in to the switch through ACLI
to a user-defined value. The banner cannot exceed 1539 bytes, or 19 rows by 80 columns plus
line termination characters.
The banner control setting is saved to NVRAM, and both the banner file and control setting
are distributed to all units within a stack.
To customize ACLI banner using ACLI, see the following commands:
•
show banner command
•
banner command
•
no banner command
show banner command
The show banner command displays the banner.
The syntax for the show banner command is:
show banner [static | custom]
Run the show banner command in Privileged EXEC command mode.
The following table describes the parameters for the show banner command.
Table 37: show banner parameters
Parameters and
variables
static | custom
Configuration — System
on page 103
on page 104
on page 104
Specify which banner is currently set to be displayed:
Customizing ACLI banner
Description
April 2011
103