Automatically Downloading A Configuration File - Avaya 4524GT Configuration Manual

save config
The save config command is in the exec command mode.
The save config command has no parameters or variables.

Automatically downloading a configuration file

Enable this feature through ACLI by using the configure network and script load-
on-boot command. Use these commands to immediately load and run a script and to
configure parameters to automatically download a configuration file when the switch or stack
is booted.
Important:
When you use the TFTP address parameter to perform copy or download commands, the
system overwrites the TFTP server address
The syntax for the configure network command is
configure network load-on-boot {disable | use-bootp | use-config}
address <XXX.XXX.XXX.XXX> filename <name>
Table 28: configure network parameters
command.
Table 28: configure network parameters
load-on-boot {disable | use-bootp |
use-config}
address <XXX.XXX.XXX.XXX>
filename <name>
Configuration — System
Parameter
on page 93 outlines the parameters for this
Description
The settings to automatically load a configuration file
when the system boots:
• disable: disable the automatic loading of config file
• use-bootp: load the ASCII configuration file at boot
and use BootP to obtain values for the TFTP
address and file name
• use-config: load the ASCII configuration file at boot
and use the locally configured values for the TFTP
address and file name
Important:
If you omit this parameter, the system immediately
downloads and runs the ASCII configuration file.
The IP address of the TFTP server.
The name of the configuration file to use in this
process
Configuration files in ACLI
April 2011 93