Avaya 4524GT Configuration Manual page 222

System configuration using Enterprise Device Manager
AutoPvid
StackInsertionUnitNumber
NextBootMgmtProtocol
CurrentMgmtProtocol
BootMode
222 Configuration — System
Variable Value
• running—the switch remains in the running
mode
• reboot—starts the reboot sequence
When enabled, a VLAN ID can be
automatically assigned to any port.
Specifies the unit number to assign to the
next unit added to the stack. Values range
from 0–8.
You cannot set the value to the unit number
of an existing stack member. When a new
unit joins the stack, and the value of this
object is used as its unit number, the value
reverts to 0. If the value of this object is 0, it
is not used to determine the unit number of
new units.
Indicates the transport protocols to use after
the next switch restart. This is a read-only
item.
Indicates the current transport protocols that
the switch supports. This is a read-only
item.
Specifies whether to use the BootP or DHCP
server to assign an IPv4 address for the
management VLAN at the next switch
reboot. Values include:
• other—read only
• bootpDisabled—use configured server IP
address
• bootpAlways—always use the BootP
server
• bootpWhenNeeded—use the BootP
server when needed
• bootpOrLastAddress—use the BootP
server last used
• dhcp—always use the DHCP server
• dhcpWhenNeeded—use the DHCP server
when needed
• dhcpOrLastAddress—use the DHCP
server last used
April 2011