Avaya 4524GT Configuration Manual page 221

6. In the sysName field, type a system name.
7. In the sysLocation field, type a system location.
8. To enable authentication traps, select the Authentication Traps check box.
9. In the ReBoot section, click a radio button.
10. In the AutoPvid section, click a radio button.
11. In the StackINsertionUnitNumber field, type a value.
12. In the BootMode section, click a radio button.
13. Click Apply .
Variable definitions
Use the data in this table to view and modify the system level configuration.
sysDescr
sysUpTime
sysObjectID
sysContact
sysName
sysLocation
SerNum
AuthenticationTraps
Reboot
Configuration — System
OR
To disable authentication traps, clear the Authentication Traps checkbox.
Variable
Configuring system parameters using EDM
Value
Provides device specific information. This is
a read-only item.
Indicates the amount of time since the
system was last booted.
Indicates the system object identification
number. This is a read-only item.
Specifies contact information for the system
administrator, which can include a contact
name or email address.
Specifies a unique name to describe this
switch.
Specifies the physical location of this
device.
Indicates the serial number of this switch .
Enables or disables authentication traps.
• When enabled, SNMP traps are sent to
trap receivers for all SNMP access
authentication.
• When disabled, no SNMP traps are
received.
Provides the action to reboot the switch.
April 2011 221