Avaya 4524GT Configuration Manual page 318

System configuration using Enterprise Device Manager
12. Double-click the PolicyPriority field.
13. Type a priority value.
14. Double-click the PolicyDscp field.
15. Type a DSCP value.
16. To use a tagged VLAN, select the PolicyTagged checkbox.
17. Click Insert .
Variable definitions
Use the data in the following table to create a new LLDP MED policy for the local system.
PortNum
PolicyAppType
PolicyVlanID
PolicyPriority
PolicyDscp
PolicyTagged
318 Configuration — System
OR
To use an untagged VLAN, clear the PolicyTagged checkbox.
Field Description
Specifies the port on which to configure
LLDP MED policies.
Specifies the policy application type.
• voice—selects the voice network policy
• voiceSignaling—selects the voice
signalling network policy
Specifies the VLAN identifier for the selected
port or ports. Values range from 1–4094. If
you select priority tagged frames, the system
recognizes only the 802.1p priority level and
uses a value of 0 for the VLAN ID of the
ingress port.
Specifies the value of the 802.1p priority that
applies to the selected switch port or ports.
Values range from 0–7. The default value is
6.
Specifies the value of the Differentiated
Service Code Point (DSCP) as defined in
IETF RFC 2474 and RFC 2475 that is
associated with the selected switch port or
ports. Values range from 0–63. The default
value is 46.
Specifies the type of VLAN tagging to apply
on the selected switch port or ports.
• when selected—uses a tagged VLAN
• when cleared—uses an untagged VLAN or
does not support port-based VLANs.
April 2011