Avaya 4524GT Configuration Manual page 148

System configuration using ACLI
• no rate-limit command
• default rate-limit command
show rate-limit command
The show rate-limit command displays the rate-limiting settings and statistics.
The syntax for the show rate-limit command is
show rate-limit
Run the show rate-limit command in Privileged EXEC command mode.
rate-limit command
The rate-limit command configures rate-limiting on the port.
The syntax for the rate-limit command is
rate-limit [port <portlist>] {multicast <pct> | broadcast <pct> |
both <pct>}
Run the rate-limit command in Interface Configuration command mode.
The following table describes the parameters for this command.
Table 64: Rate-limit parameters
Parameters and values
port <portlist>
multicast <pct> |
broadcast <pct> | both
<pct>
148 Configuration — System
on page 149
on page 149
Specify the port numbers to configure for rate-limiting. Enter the
port numbers to configure.
Important:
If you omit this parameter, the system uses the port number
you specified in the interface
Apply rate-limiting to the type of traffic. Enter an integer from 1–
10 to set the rate-limiting percentage:
• multicast: Apply rate-limiting to multicast packets.
• broadcast: Apply rate-limiting to broadcast packets.
• both: Apply rate-limiting to both multicast and broadcast
packets.
Description
command.
April 2011