Configuring System Ip Addresses And Boot Mode; Copy Config Nvram Block Command; Copy Nvram Config Block Command - Avaya 4524GT Configuration Manual

Important:
The Last Saved time is not available even if SNTP is active. ERS4500 switch does not have
a RTC (Real Time Clock).
Run this command in Global Configuration command mode.

copy config nvram block command

This command copies the current configuration to one of the flash memory locations. The
syntax for this command is
copy config nvram block <1-2> name <block_name>
Table 47: copy config nvram block parameters
command.
Table 47: copy config nvram block parameters
Parameter
block <1—2>
name <block_name>
Run this command in Global Configuration command mode.

copy nvram config block command

This command copies the configuration stored in flash memory at the specified location and
makes it the active configuration. The syntax for this command is
copy nvram config block <1-2>
Substitute <1-2> with the configuration file to load.
This command resets the switch to reset so that the new configuration load.
Run this command in Global Configuration command mode.

Configuring system IP addresses and boot mode

Configure, clear, and view IP addresses, gateway addresses, and boot mode information . For
details, see:
• ip address command
• default ip address command
Configuration — System
on page 131 outlines the parameters for this
The flash memory location to store the configuration.
Name to attach to this block. Names can be up to 40 characters
in length with no spaces.
on page 132
on page 133
General switch administration using ACLI
Description
April 2011 131