Chapter 8: Configuration Reference; Factory Default Configuration - Avaya 4524GT Configuration Manual

Chapter 8:
The sections in this chapter provide information on the factory default configuration.

Factory default configuration

When you initially access a newly installed switch or you reset a switch to factory defaults, the
switch is in a factory default configuration. This factory default configuration is the base
configuration from which you build the switch configuration.
Table 93: Factory default configuration settings
configuration settings present in a switch in a factory default state.
Table 93: Factory default configuration settings
Unit Select switch
Unit
BootP Request Mode
In-Band Stack IP Address
In-Band Switch IP Address
In-Band Subnet Mask
Default Gateway
Read-Only Community String
read/write Community String
Trap IP Address
Community String
Authentication Trap
Autotopology
sysContact
sysName
sysLocation
Aging Time
Configuration — System
Configuration reference
Setting
non-Base
1
BootP When Needed
0.0.0.0 (no IP address assigned)
0.0.0.0 (no IP address assigned)
0.0.0.0 (no subnet mask assigned)
0.0.0.0 (no IP address assigned)
public
private
0.0.0.0 (no IP address assigned)
Zero-length string
Enabled
Enabled
Zero-length string
Zero-length string
Zero-length string
300 seconds
on page 357 outlines the factory default
Factory default configuration value
April 2011 357