Changing The Configuration For Specific Interface Ports Using Edm - Avaya 4524GT Configuration Manual

Ethernet routing switch 4500 series
Table of Contents

Advertisement

Variable
LastChange
LinkTrap
AutoNegotiate
AdminDuplex
OperDuplex
AdminSpeed
OperSpeed
AutoNegotiationCapabilit
y
AutoNegotiation
Advertisments
MltId
IsPortShared
PortActiveComponent

Changing the configuration for specific interface ports using EDM

Use this procedure to modify configuration parameters for one or more interface ports.
Configuration — System
prevents it from going to the up state. The testing state indicates
that no operational packets can be passed.
The value of sysUpTime at the time the interface entered its
current operational state. If the current state was entered prior
to the last reinitialization of the local network management
subsystem, the value is zero.
Specifies whether linkUp/linkDown traps should be generated
for this interface.
Indicates whether this port is enabled for autonegotiation or
not.
Important:
10/100BASE-TX ports can not autonegotiate correctly with
older 10/100BASE-TX equipment. In some cases, the older
devices can be upgraded with new firmware or driver
revisions. If an upgrade does not allow autonegotiation to
correctly identify the link speed and duplex settings, you can
manually configure the settings for the link in question.
The current administrative duplex mode of the port (half or
full).
The current mode of the port (half duplex or full duplex).
Set the port's speed.
The current operating speed of the port.
Specifies the port speed and duplex capabilities that a switch
can support on a port, and that can be advertised by the port
using auto-negotiation.
Specifies the port speed and duplex abilities to be advertised
during link negotiation.
The MultiLink Trunk to which the port is assigned (if any).
Specifies whether a port is shared. Multiple ports that are
logically represented as a single port are shared. Only one
shared port can be active at a time.
Specifies the physical port components that are active for a
shared port.
Interface port management using EDM
Value
April 2011
231

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents