Renumbering Stack Switch Units Using Edm - Avaya 4524GT Configuration Manual

System configuration using Enterprise Device Manager
Variable definitions
Use the information in the following table to help you understand the base unit information
display.
Type
Descr
Ver
SerNum
LstChng
AdminState
OperState
Location
RelPos
BaseNumPorts
TotalNumPorts
IpAddress
RunningSoftwareVer

Renumbering stack switch units using EDM

Use this procedure to change the unit numbers of switches in a stack.
228 Configuration — System
Variable
Indicates the switch type.
Describes the switch hardware, including number of ports
and transmission speed.
Indicates the switch hardware version number.
Indicates the switch serial number.
Indicates the value of sysUpTime at the time the interface
entered its current operational state. If you entered the
current state prior to the last reinitialization of the local
network management subsystem, the value is zero.
Specifies the administrative state of the base unit switch.
Values include enable or reset.
Indicates the operational state of the switch.
Specifies the physical location of the switch.
Indicates the relative position of the switch.
Indicates the number of base ports of the switch.
Indicates the number of ports of the switch.
Indicates the base unit IP address.
Indicates the version of the running software.
Value
Important:
In a stack configuration, the
only the base unit.
reset command resets
April 2011