Avaya 4524GT Configuration Manual page 193

Figure 13: LLDP configuration example
To configure the example shown in the preceding figure, you must perform the following tasks:
1. Modify the default LLDP Tx interval from (the default 30 second value) to 60
2. Enable the Port Description TLV for transmission. (contains the description of the
3. Enable the System Name TLV for transmission. (contains the name of the LLDP
4. Enable the System Description TLV for transmission. (contains the description of
5. Enable the System Capabilities TLV for transmission. (contains the capabilities of
6. Enable the Management Address TLV for transmission. (contains the management
7. Enable the Port VLAN ID TLV for transmission. (contains the PVID of the LLDP
8. Enable the Port And Protocol VLAN ID TLV for transmission. (indicates the Port and
9. Enable the VLAN Name TLV for transmission. (indicates the names of the VLANs
Configuration — System
seconds.
Note that if any modification is detected in the LLDP local-sys-data before the Tx
interval expires, an LLDPDU is immediately sent on all active links to update the
peers neighbor tables.
LLPD sending port)
device)
the LLDP device)
the LLDP device)
address of the LLDP device)
sending port)
Protocol VLANs to which the LLDP sending port belongs to).
to which the LLDP sending port belongs to)
Configuring LLDP using ACLI
April 2011 193