System configuration using ACLI
default lldp command
The default lldp command sets the LLDP transmission parameters to their default values.
The syntax for the default lldp command is
default lldp [tx-interval ] [tx-hold-multiplier ] [reinit-delay] [tx-
delay] [notification-interval] [med-fast-start]
If no parameters are specified, the default lldp sets all parameters to their default
parameters.
Run the default lldp command in Global Configuration command mode.
The following table describes the variables for the default lldp command.
Table 81: default lldp command variables
tx-interval
tx-hold-multiplier
reinit-delay
tx-delay
notification-interval
med-fast-start
default lldp port command
The default lldp port command sets the port parameters to their default values. The
syntax for the default lldp port command is
default lldp port <portlist> [config notification] [status]
Run the default lldp port command in Interface Configuration command mode.
The following table describes the variables for the default lldp port command.
Table 82: default lldp port command variables
port <portlist>
170
Configuration — System
Variables
Variables
Description
Set the retransmit interval to the default value (30).
Set the transmission multiplier to the default value
(4).
Set the reinitialize delay to the default value (2).
Set the transmission delay to the default value (2).
Set the notification interval to the default value (5).
Set the MED fast start repeat count to the default
value.
Description
The ports affected by the command.
April 2011