Enabling Rate-Limiting - Avaya 4524GT Configuration Manual

Run the no flowcontrol command in Interface Configuration mode.
The following table describes the parameters for this command.
Table 62: No flowcontrol parameters
Parameters and
variables
port <portlist>
default flowcontrol command
Use the default flowcontrol command only on Gigabit Ethernet ports to set the flow
control to automatic, which automatically detects the flow control.
The syntax for the default flowcontrol command is
default flowcontrol [port <portlist>]
Run the default flowcontrol command in Interface Configuration mode.
The following table describes the parameters for the command.
Table 63: Default flowcontrol parameters
Parameters and
variables
port <portlist>

Enabling rate-limiting

The percentage of multicast traffic, or broadcast traffic, or both, can be limited using ACLI. For
details, see the following sections:
• show rate-limit command
• rate-limit command
Configuration — System
Specify the port numbers for which to disable flow control.
Important:
If you omit this parameter, the system uses the ports you
specified in the interface
that have speed set to 1000/full.
Specify the port numbers to default to automatic flow control.
Important:
If you omit this parameter, the system uses the port number
you specified in the
on page 148
on page 148
General switch administration using ACLI
Description
command, but only those ports
Description
interface command.
April 2011 147