Default Lldp Tx-Tlv Dot3 Command; Default Lldp Tx-Tlv Med Command - Avaya 4524GT Configuration Manual

default lldp tx-tlv dot3 command

The default lldp tx-tlv dot3 command sets the optional IEEE 802.3 organizationally-
specifc TLVs to their default values. The syntax for the default lldp tx-tlv dot3
command is
default lldp tx-tlv [port <portlist>] dot3 [mac-phy-config-status]
[mdi-power-support] [link-aggregation][maximum-frame-size]
Run the default lldp tx-tlv dot3 command in Interface Configuration command
mode.
The following table describes the variables for the default lldp tx-tlv dot3
command.
Table 86: default lldp tx-tlv dot3 command variables
port <portlist>
mac-phy-config-status
mdi-power-support
link-aggregation
maximum-frame-size

default lldp tx-tlv med command

The default lldp tx-tlv med command sets default values for the optional
organizationally specific TLVs for use by MED devices to be included in the transmitted
LLDPDUs. The syntax for the default lldp tx-tlv med command is:
default lldp tx-tlv [port <portlist>] med [med-capabilities]
[extendedPSE] [inventory] [location] [network-policy]
The default lldp tx-tlv med command is in the config-if command mode.
The following table lists the variables for the default lldp tx-tlv med command.
Configuration — System
Variables Description
The ports affected by the command.
The MAC/Phy Configuration/Status TLV (default value
is false: not included).
The power via MDI TLV. This TLV is enabled by
default.
The link aggregation TLV (default value is false: not
included).
The maximum frame size TLV (default value is false:
not included).
Configuring LLDP using ACLI
April 2011 173