Initiating A Cable Diagnostic Test Using Acli - Avaya 4524GT Configuration Manual

Table 60: Default duplex variables
Variables
port <portlist>

Initiating a cable diagnostic test using ACLI

Use the information in this section to initiate and display results for a cable diagnostic test
globally, or for one or more specific switch ports, using the Time Domain Reflectometer
(TDR).
tdr test command
The tdr test command initiates a cable diagnostic test globally, or for one or more specific
switch ports.
The syntax for the tdr test command is
tdr test <portlist>
Run the tdr test command in Privileged EXEC command mode.
Variable definitions
The following table defines optional parameters that you can enter after the tdr test
command.
<WORD>
show tdr test command
The show tdr test command displays cable diagnostic test results globally, or for one or
more specific switch ports.
The syntax for the show tdr test command is
show tdr test <portlist>
Run the show tdr test command in Privileged EXEC command mode.
Configuration — System
Specify the port numbers for which to reset the duplex mode to
factory default values. Enter the port numbers to configure. The
default value is autonegotiation.
Important:
If you omit this parameter, the system uses the ports you
specified in the
Variable
General switch administration using ACLI
Description
interface command.
Value
Specifies a port or list of ports.
April 2011 143