Chapter 7: Enterprise Device Manager
This section contains procedures for starting and using Enterprise Device Manager (EDM). The software
is built-in to the switch so there is no need to install any additional software. For information about general
EDM concepts, see
Enterprise Device Manager
Enabling the Web server using the CLI
Disabled by default, you can enable or disable Web access using the config web-
server command.
Use the following procedure to enable and manage the Web server using the CLI. After you
enable the Web server, you can start EDM.
Procedure steps
Enable and manage the Web server using the following command:
config web-server enable
For more information, see the following Variable definitions table.
Variable definitions
Use the data in the following table to use the config web-server command.
Table 7: Variable definitions
def-display-rows <integer>
disable
enable
User Interface Fundamentals
procedures
Variable
Sets the number of rows displayed on each page.
• integer is 10 to 100.
Disables the Ethernet Routing Switch Web interface.
Enables the Ethernet Routing Switch Web interface.
on page 14.
Value
July 2013
49