Chapter 5: ACLI procedures
Configuring EDM through ACLI
This section describes how to enable and configure the Enterprise Device Manager (EDM)
using ACLI.
Enabling the Web server using ACLI
The Web server is enabled by default. If you have assigned an IP address to the switch you
can access EDM.
If you have disabled the Web server, use this procedure to enable and manage the Web server
using ACLI. After you enable the Web server you can start EDM. For more information about
the Web server, see Avaya Ethernet Routing Switch 3500 Configuration — Security
(NN47203–504).
Procedure
1. Log on to the Global Configuration mode in ACLI.
2. At the command prompt, enter the following command:
Disabling the Web server using ACLI
Use this procedure to disable the Web server using ACLI. After you disable the Web server,
you cannot start EDM.
Before you begin
• Open an ACLI session.
Procedure
1. Log on to the Global Configuration mode in ACLI.
Fundamentals of ERS 3500 Series
web-server enable
March 2014
33