Configuring An Access-Port-Based Vlan - H3C S5500-EI series Operation Manual

Operation Manual – VLAN
H3C S5500-EI Series Ethernet Switches
Port type
Trunk port
Hybrid port

1.4.2 Configuring an Access-Port-Based VLAN

There are two ways to configure Access-port-based VLAN: one way is to configure in
VLAN view, the other way is to configure in Ethernet port view/port group view.
Follow these steps to configure the Access-port-based VLAN in VLAN view:
Enter system view
Enter VLAN view
Add an Access port to the
current VLAN
Inbound packets handling
If no tag is
carried in the
packet
Check whether
the default
VLAN ID of the
port is in the list
of VLANs
allowed to pass
through the
port, if yes, tag
the packet with
the default
VLAN ID; if no,
discard the
packet
To do...
system-view
vlan vlan-id
port interface-list
If a tag is carried in the
packet
Receive the packet if
the VLAN ID is in the
list of VLANs allowed
to pass through the
port
Discard the packet if
the VLAN ID is not in
the list of VLANs
allowed to
through the port
Use the command...
1-8
Chapter 1 VLAN Configuration
Outbound packets
handling
Strip the tag and
send the packet if
the VLAN ID is the
same as
default VLAN ID
Keep the tag and
send the packet if
the VLAN ID is not
the same as the
default VLAN ID
but allowed
pass through the
port
Send the packet if the
VLAN ID is allowed to
pass
pass through the port.
Use the port hybrid
vlan command to
configure whether the
port keeps or strips
the tags when
sending packets of a
VLAN (including the
default VLAN).
Remarks
—
Required
If the specified VLAN
does not exist, this
command be created first
creates the VLAN before
entering its view.
Required
By default, system will
add all ports to VLAN 1.
the
to