Assigning An Access Port To A Vlan - H3C S5500-SI Series Operation Manual

Do not set the voice VLAN as the default VLAN of a port in automatic voice VLAN assignment
mode. Otherwise, the system prompts error information. For information about voice VLAN, refer to
Voice VLAN
The local and remote ports must use the same default VLAN ID for the traffic of the default VLAN to
be transmitted properly.
A port configured with the default VLAN handles a frame as follows:
Port type
Tag the frame with
Access the default VLAN
tag.
Check whether the
Trunk
default VLAN is
permitted on the
port:
Hybrid

Assigning an Access Port to a VLAN

You can assign an access port to a VLAN in VLAN view, interface view, or port group view.
1) In VLAN view
Follow these steps to assign one or multiple access ports to a VLAN in VLAN view:
To do...
Enter system view
Enter VLAN view
Assign one or a group
of access ports to the
current VLAN
Configuration.
Actions (in the inbound direction)
Untagged frame
If yes, tag the
frame with the
default VLAN
tag.
If not, drop the
frame.
Use the command...
system-view
vlan vlan-id
port interface-list
Tagged frame
Receive the frame if its
VLAN ID is the same
as the default VLAN ID.
Drop the frame if its
VLAN ID is different
from the default VLAN
ID.
Receive the frame if its
VLAN is carried on the
port.
Drop the frame if its
VLAN is not carried on
the port.
—
Required
If the specified VLAN does not exist, this
command creates the VLAN first.
Required
By default, all ports belong to VLAN 1.
1-6
Actions (in the outbound
direction)
Remove the default VLAN tag and
send the frame.
Remove the tag and send the
frame if the frame carries the
default VLAN tag.
Send the frame
removing the tag if its VLAN is
carried on the port but is
different from the default one.
Send the frame if its VLAN is
carried on the port. The frame is
sent with the VLAN tag removed
or intact depending on your
configuration with the port hybrid
vlan command. This is true of the
default VLAN.
Remarks
without