Checking The Engine Oil Level - Toro 22323G Operator's Manual

1. Remove the fuel tank cap (Figure 16).
Figure 16
1. Fuel tank cap
2. Fill the tank to about one inch below the top of the
tank, not the filler neck, with diesel fuel.
3. Install the fuel tank cap.

Checking the Engine Oil Level

Service Interval: Before each use or daily
1. Park the traction unit on a level surface, lower the
loader arms, and stop the engine.
2. Remove the key and allow the engine to cool.
3. Open the hood.
4. Clean around the oil dipstick (Figure 17).
1. Oil dipstick
5. Pull out the dipstick and wipe the metal end clean
(Figure 17).
6. Slide the dipstick fully into the dipstick tube (Figure 17).
7. Pull the dipstick out and look at the metal end.
8. If the oil level is low (below the bottom hole), clean
around the oil filler cap and remove the cap (Figure 17).
9. Slowly pour only enough oil into the valve cover to
raise the level to the top hole on the dipstick.
Important: Do not overfill the crankcase with oil
because the engine may be damaged.
10. Replace the filler cap and dipstick.
11. Close the hood.
18
Figure 17
2. Oil filler cap