Installing A New Multi-Module Library Configuration - Quantum scalar i500 User Manual

Installing a New Multi-Module Library Configuration

Scalar i500 User's Guide
14 Add the tape cartridges to the library using the I/E station.
15 If your host application inventories the location of each tape cartridge
in the library, open the host application and re-inventory to sync the
logical inventory with the physical inventory of the library.
Use this procedure for installing a new multi-module library. A multi-
module library contains a control module and up to four expansion
modules.
There are no restrictions on where the control module can be installed in
the library configuration. However, the recommended placement of the
control module for library configurations up to 32U is on top of all
installed 9U expansion modules. The recommended placement of the
control module for 41U library configurations is on top of three 9U
expansion modules and below the top expansion module.
Expansion Module
Control Module
Expansion Module
Expansion Module
Expansion Module
Chapter 12 Installing, Removing, and Replacing
Installing a New Multi-Module Library Configuration
330