Working With Control Paths; Table 5 Control Path Assignment During Partition Creation - Quantum scalar i500 User Manual

Working With Control Paths

Table 5 Control Path
Assignment During Partition
Creation
And the
If the library partition
contains: contains:
No FC I/O Any
blades combination
of tape drive
interface types
(SCSI, FC, or
SAS)
Scalar i500 User's Guide
The paths to open the appropriate screens are as follows:
• From the Web client, select
• From the operator panel, select
The control path tape drive is used to connect a partition to a host
application.
The library automatically assigns control paths when you set up
partitions. You can modify the control path at any time.
how these control paths are assigned and how to change them.
Then the
default
control path
for the
partition is:
The first tape
drive assigned
to the partition
Chapter 3 Configuring Your Library
Setup > Drive Settings
Setup > Drive Settings
If you want to change the control path, note the
following:
You must select a tape drive as the control path.
Working With Control Paths
.
.
Table 5 describes
86