Working With Ras E-Mail Notifications - Quantum scalar i500 User Manual

Working With RAS E-mail Notifications

Scalar i500 User's Guide
•
Send a test e-mail to
want to test. Enter the address and click
the e-mail account to verify that an e-mail message was sent from
the library.
After configuring the e-mail account, save the library configuration. For
information, see Saving and Restoring the Library Configuration
page 494.
You can configure the library e-mail account from the Web client only,
but you can view e-mail account information from the operator panel.
The paths to open the appropriate screens are as follows:
• From the Web client, select
.
Configuration
• From the operator panel, select
The library can be configured to automatically send e-mail notifications
to specified e-mail addresses whenever an issue of a particular severity
level occurs with one of its components. The information in the e-mail
notification provides details about the issue and the library conditions at
the time of the error.
Before you can configure e-mail notifications, you must configure the
library's e-mail account so that the library can send notifications to the
designated recipients. See
page 92 for information on how to configure the e-mail account.
See Creating RAS E-mail Notifications
setting up additional e-mail notifications. The library supports a
maximum of 20 e-mail notification recipients, including the default
support e-mail notification.
Note: RAS e-mail notifications are closed when the library reboots.
From the operator panel, select
configure this setting.
Chapter 3 Configuring Your Library
Working With RAS E-mail Notifications
allows you to enter an e-mail address you
Setup > Notifications > E-mail
Setup > Notification > E-Mail Account
Configuring the Library E-mail Account
on page 95 for information on
Tools > System Settings
. Then check
Send e-mail
on
on
to
.
94