Figure 15 Ldap Setup Example - Quantum scalar i500 User Manual

Figure 15 LDAP Setup
Example
The simple LDAP server
configuration shown below would
give the library settings shown at
right.
Simple LDAP Server Configuration:
Scalar i500 User's Guide
page 50 for information on privilege levels). This group must exist on
your LDAP server (see
example, see Figure 15.
Testing LDAP Settings
The button tests communication between the library and the
Test Settings
LDAP server, and tests the currently applied LDAP settings. If there are
any problems, an error message identifies the problem area.
If you change the LDAP settings, click
testing them. Otherwise, any changes you made will be lost and will not
be tested.
To test the settings, you must type a user name and password, then click
the button.
Test Settings
Chapter 3 Configuring Your Library
LDAP Server Guidelines
to save your changes before
Apply
The user you use for the test must be a member of
Working With User Accounts
on page 100). For an
3
103