Restarting The Library; Logging In - Quantum scalar i500 User Manual

Restarting the Library

Logging In

Scalar i500 User's Guide
The paths to open the appropriate screens are as follows:
• From the Web client, select
• From the operator panel, select
The command shuts down and restarts the library's operating
Restart
system and firmware. When performing a restart, the library finishes the
current command, then shuts down the library and restarts it. During the
restart, the library brings all tape drives and partitions online and
performs an inventory of cartridges, tape drives, and slots.
Before performing a restart, make sure the connected host applications
are not sending commands to the library.
Restarting takes approximately 5 minutes for the control module and
longer for the 14U and higher library configurations.
If the "Not Initialized" message appears on the operator panel after the
restart process is complete, the library did not properly initialize. View
the screen to find the problem that is preventing the
All RAS Tickets
library from properly initializing. See
The paths to open the appropriate screens are as follows:
• From the Web client, select
• From the operator panel, select
All users, service users, and administrators must log in to the library to
perform library functions or view library operations.
Chapter 9 Running Your Library
Operations > System Shutdown
Operations > Shutdown
Viewing RAS Tickets
Operations > System Shutdown
Operations > Shutdown
Restarting the Library
.
.
on page 488.
.
.
243