Resetting Fc I/O Blade Ports - Quantum scalar i500 User Manual

Resetting FC I/O Blade Ports

Scalar i500 User's Guide
Note: This operation should not be performed concurrently by
multiple administrators logged in from different locations.
You can access the appropriate screens, but you cannot apply
changes while another administrator is performing the same
operation.
The paths to open the appropriate screens are as follows:
• From the Web client, select
.
Control
• From the operator panel, select
Control > Remove Blade
Administrators can reset individual ports on FC I/O blades. Resetting
these ports can help troubleshoot FC I/O blade issues. The
screen allows you to perform the Reset Port operation on a
Control
selected FC I/O blade port.
Resetting an FC I/O blade port will cause a temporary loss of
communication with connected hosts. The screen will display a warning
message about the communication loss and ask you to confirm that you
want to proceed.
Note: This operation should not be performed concurrently by
multiple administrators logged in from different locations.
You can access the appropriate screens, but you cannot apply
changes while another administrator is performing the same
operation.
Note: Before resetting FC I/O blade ports, verify the location of the
FC I/O blade. See
Chapter 13 Troubleshooting
Resetting FC I/O Blade Ports
Setup > FC I/O Blades > FC I/O Blade
Setup > FC I/O Blades > FC I/O Blade
.
Identifying FC I/O Blades
Setup - Blade
on page 502.
504