Viewing, Saving, And E-Mailing Library Logs - Quantum scalar i500 User Manual

Viewing, Saving, and E-mailing Library Logs

Scalar i500 User's Guide
• — Location coordinates of the slot. (For a description of
Location
location coordinates, see
page 32.)
•
Element Address
• — The encryption state of the media in the slot. In order
Encryption
for the library to know the encryption state, the tape must have been
placed into an encryption-capable tape drive in the library. The
encryption-capable tape drive reads and records the encryption state
of the tape, and the encryption state displays as "Encrypted" or "Not
Encrypted." If the tape was not placed into an encryption-capable
tape drive in the library, or if the slot is empty, the encryption state
displays as "Unknown."
— The number of times the picker successfully removed a
• Get Count
tape from the slot.
— The number of times the picker had to perform a
• Get Retries
recovery operation to remove a tape from the slot.
— The number of times the picker successfully placed a
• Put Count
tape into the slot.
— The number of times the picker had to perform a
• Put Retries
recovery operation to place a tape into the slot.
"Get" and "put" counts and retries are counted from the
Note:
beginning of library use to the present. If the LCB compact
flash card is replaced, the count starts over at zero.
The path to open the report from the Web client is
The library collects specific information in log files that you can view
onscreen, save to your computer, or e-mail to a recipient. The following
library logs are available:
•
Installation Verification Test Summary Log
time you run the Installation Verification Test (IVT). The log saves
only the information from the most recently run test. If you run the
Chapter 10 Getting Information – Logs and Reports
Viewing, Saving, and E-mailing Library Logs
Understanding the Location Coordinates
— Element address of the slot.
Reports > All Slots
— This log is saved each
on
.
277