Adding An Fc I/O Fan Blade - Quantum scalar i500 User Manual

Adding an FC I/O Fan
Blade
Scalar i500 User's Guide
Figure Figure 62
installed side-by-side in the expansion module.
These instructions explain how to add an FC I/O fan blade to your
12
library. You can add an FC I/O fan blade while the library is powered on.
Required tools:
1 Access the back of the expansion module.
2 Remove the cover plate from blade bay to the right of the bay for the
FC I/O blade.
Note:
3 Press up and out to open the latch hooks on each side of the FC I/O
fan blade. The LED must be at the bottom of the blade.
Chapter 12 Installing, Removing, and Replacing
Adding, Removing, and Replacing the FC I/O Fan Blade
on page 451 shows the FC I/O blade and I/O fan blade
None
The recommended order of installing the FC I/O blade
and fan blade in an expansion module is starting from the
bottom two bays and moving up.
461